RAM 2500 Truck 2WD V8-5.2L VIN Y (2000)
Wiper Pivot: Description and Operation
The wiper linkage and pivot module is secured with four screws through four rubber grommet-type insulators to the cowl plenum panel beneath the cowl
plenum cover/grille panel. The wiper motor is secured with screws near the center of the tubular linkage and pivot module bracket, and the wiper pivots
are secured to the ends of the module bracket.
The two wiper pivot crank arms and the wiper motor crank arm each have ball studs on their ends.
The motor crank arm ball stud is the longer of the three. Two drive links connect the motor crank arm to the pivot crank arms.
The passenger side drive link has a plastic socket- type bushing on each end. The driver side drive link has a plastic socket-type bushing on one end, and
a plastic sleeve-type bushing on the other end. The socket-type bushing on one end of each drive link is snap-fit over the ball stud on the crank arm of its
respective pivot. The driver side drive link sleeve- type bushing end is then fit over the motor crank arm ball stud, and the second socket-type bushing of
the passenger side drive link is snap-fit over the exposed end of the motor crank arm ball stud.
The wiper linkage, pivots, bushings, mounting bracket, and motor are only serviced as a complete unit. If any part of this assembly is faulty or damaged,
the entire wiper module must be replaced.
