RAM 2500 Truck 2WD V8-5.7L (2008)
Hood Sensor/Switch (For Alarm): Service and Repair
Hood Ajar Switch Bracket
Removal
BRACKET
1. Remove the hood ajar switch (2) from the mounting bracket (3). See: Hood Ajar Switch - Removal .
2. Remove the two screws (4) that secure the hood ajar switch bracket to the two rivet nuts (1) in the right front load beam (6).
3. Remove the hood ajar switch mounting bracket from the inboard side of the right front load beam.
Installation
BRACKET
1. Check to be certain that the two rivet nuts (1) on the inboard side of the right front load beam (6) are in good condition and properly secured.
2. Position the hood ajar switch mounting bracket (3) onto the right front load beam.
3. Install and tighten the two screws (4) that secure the mounting bracket to the load beam. Beginning with the rearward screw, tighten both screws to
8 Nm (71 in. lbs.).
4. Reinstall the hood ajar switch (2) into the mounting bracket. See: Hood Ajar Switch - Installation .
