RAM 2500 Truck 2WD V8-5.7L (2008)
Evaporative Emission Control Canister: Service and Repair
Removal
REMOVAL
Type-1 Canisters
A single, vertically mounted EVAP canister (1) is used with Type 1. The ESIM (Emission System Integrity Monitor) switch (3) is mounted to the
canister.
1. Raise and support vehicle.
2. If equipped, remove necessary skid plates. Certain models, equipped with a certain fuel tank size, may require the removal of the fuel tank skid
plate and/or the transfer case skid plate to gain access to the EVAP canister(s).
3. Disconnect electrical wiring connector from ESIM switch (3).
4. Disconnect vapor line (6) from ESIM switch.
5. Disconnect quick-connect vapor line (5) from canister.
6. Remove canister mounting bracket bolt. This is located below and near the ESIM switch.
7. Pull canister from mounting bracket while guiding two canister locating pins from mounting bracket.
Type-2 Canisters
A single, vertically mounted EVAP canister (1) is used with Type 2. The ESIM (Emission System Integrity Monitor) switch (2) is mounted to the
canister.
1. Raise and support vehicle.
