RAM 2500 Truck 2WD V8-5.7L (2008)
7. Align the snap features on the upper shroud with the receptacles in the lower shroud and apply hand pressure to snap them together.
8. Install and tighten the two outboard screws that secure the upper shroud to the lower shroud. Tighten the screws to 2 Nm (20 in. lbs.).
9. Position the tilt steering column knob (1) onto the tilt adjuster actuator (3) on the left side of the steering column, then install and tighten the screw
(2) to secure the knob to the actuator. Tighten the screw to 2 Nm (20 in. lbs.).
10. Reconnect the battery negative cable.
NOTE: On vehicles equipped with the optional Sentry Key Immobilizer System (SKIS) if the SKREEM is replaced with a new unit, a
diagnostic scan tool MUST be used to initialize the new SKREEM and to program at least two Sentry Key transponders before the
vehicle can be operated. See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming
and Relearning.
