RAM 2500 Truck 2WD V8-5.7L (2008)
Seat Occupant Classification Module - Air Bag: Service and Repair
Occupant Restraint Controller (ORC) Module Cover - Removal
COVER
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
NOTE: The front seat assembly must be unfastened from the floor panel, but need not be removed from the vehicle for access to the
Occupant Restraint Controller (ORC) cover for service.
2. Remove the front seat from the vehicle. See: Body and Frame/Seats/Service and Repair/Seat - Removal .
3. Using a trim stick or another suitable wide flat-bladed tool, gently pry the latch feature on either side of the ORC cover (1) away from the base of
the ORC (2) far enough to disengage the cover from the module.
4. Remove the ORC cover from over the ORC.
