RAM 2500 Truck 2WD V8-5.7L (2008)
Seat Occupant Classification Module - Air Bag: Service and Repair
Occupant Restraint Controller (ORC) Module Cover - Installation
COVER
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
1. Position the ORC cover (1) over the Occupant Restraint Controller (ORC) (2).
2. Align the latch feature on each side of the ORC cover with the notch in each side at the base of the ORC housing.
3. Using hand pressure, press firmly and evenly downward on the ORC cover until each latch feature is fully engaged with the ORC housing.
4. Reinstall the front seat into the vehicle. See: Body and Frame/Seats/Service and Repair/Seat - Installation .
5. Reconnect the battery negative cable.
