RAM 2500 Truck 2WD V8-5.7L (2008)
Fuel Gauge Sender: Service and Repair
Removal
REMOVAL
WARNING: The fuel system may be under a constant pressure (even with the engine off). Before servicing the fuel pump module, the fuel
system pressure must be released.
1. Drain and remove fuel tank. Refer to Fuel Tank Removal/Installation.
2. Remove plastic fuel pump module cover (1) by pushing pegs (2) outward.
3. Note rotational position of module before attempting removal. An indexing arrow is located on top of module for this purpose.
4. Position Special Tool 9340 (3) into notches on outside edge of lockring (5).
5. Install 1/2 inch drive breaker bar (1) to tool 9340 (3).
6. Rotate breaker bar counter-clockwise to remove lockring (5).
7. Remove lockring. The module will spring up slightly when lockring is removed.
8. Remove module from fuel tank. Be careful not to bend float arm while removing.
