RAM 2500 Truck 2WD V8-5.7L (2008)
Power Steering Pressure Switch: Service and Repair
Installation - 5.7L - HD Vehicles Only
INSTALLATION - 5.7L - HD VEHICLES ONLY
This switch is used only with the 5.7L V-8 engines HD vehicles only.
1. Install power steering switch (5) into power steering line (5).
2. Tighten to 8-11 Nm (70-100 in. lbs.) torque.
3. Connect electrical connector to switch.
4. Check power steering fluid and add as necessary.
5. Start engine and again check power steering fluid. Add fluid if necessary.
