RAM 2500 Truck 2WD V8-5.7L (2008)
2. Replace the snap ring (3).
3. Install the steering knuckle See: Front Steering Knuckle/Service and Repair/Front Steering Knuckle - Installation .
4. Install the tie rod end into the steering knuckle See: Steering/Tie Rod/Tie Rod End/Service and Repair/Tie Rod End - Installation .
5. Install the brake caliper and rotor See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Installation .
6. Install the tire and wheel assembly See: Wheels and Tires/Service and Repair/Removal and Replacement .
7. Check the vehicle ride height See: Alignment/Service and Repair .
8. Perform a wheel alignment See: Alignment/Service and Repair .
4500 & 5500 - Link/Coil
4500 & 5500
1. Position special tool 9859-1 (DRIVER) (5) and 9859-2 (RECEIVER) (2) with C4212-F (PRESS) (1) as shown to install lower ball stud (4).
2. Install the steering knuckle See: Front Steering Knuckle/Service and Repair/Front Steering Knuckle - Installation .
3. Install the axle shaft into the axle.
