RAM 2500 Truck 2WD V8-5.7L (2008)
Fluid Pressure Sensor/Switch: Service and Repair
42RLE Automatic Transmission
Removal
REMOVAL
1. Remove the valve body from the transmission. See: Valve Body/Service and Repair/Removal and Replacement/42RLE Automatic
Transmission/Removal
2. Remove the electrical connectors from the pressure control solenoid (1) and the line pressure sensor (2).
3. Remove the screws (6) holding the pressure control solenoid (1) and line pressure sensor (2) to the valve body.
4. Remove the pressure control solenoid and line pressure sensor from the valve body.
Installation
INSTALLATION
1. Install the pressure control solenoid (1) and line pressure sensor (2) into the valve body.
2. Install the screws (6) to hold the pressure control solenoid (1) and line pressure sensor (2) to the valve body.
3. Install the electrical connectors to the pressure control solenoid (1) and the line pressure sensor (2).
4. Install the valve body into the transmission. See: Valve Body/Service and Repair/Removal and Replacement/42RLE Automatic
Transmission/Installation
