RAM 2500 Truck 2WD V8-5.7L (2008)
9. Remove release lever (3) and release bearing from clutch housing (1). Apply Mopar(TM) high temperature bearing grease to bore (4) of release
bearing, release lever (5) contact surfaces and release lever pivot stud (2).
10. Apply light coat of Mopar(TM) high temperature bearing grease to splines (3) of transmission input shaft (1) and to release bearing slide surface
of the transmission front bearing retainer (2).
CAUTION: Do not over lubricate shaft splines. This can result in grease contamination of the disc.
11. Wipe pilot bearing surface clean.
