RAM 2500 Truck 2WD V8-5.7L (2008)
NOTE: The inner part of the seal (3) may stay on the axle tube (2). This part must also be removed with pry bar (1).
7. Remove rear bearing.
8. Remove hub bearing cups with a hammer and drift.
Installation
INSTALLATION
1. Install outer hub bearing cup with Installer 8961 and Handle C-4171.
2. Install inner hub bearing cup with Installer 8962 and Handle C-4171.
3. Pack bearings with the appropriate grease.
4. Install rear bearing and install new grease seal with Installer 8963 and Handle C-4171.
5. Slide hub on the axle tube and install front bearing into the hub.
6. Install hub bearing nut with Socket 8954 (1) and torque wrench (2) to 30 Nm (22 ft. lbs.) while rotating the hub.
7. Back off nut about 30° and align next hub nut key slot with axle tube key slot and install locking key. End play should be 0.025-0.25 mm
(0.001-0.010 in.).
8. Install retainer ring (1) with ring end in the key slot (2).
9. Install new axle shaft gasket and install axle shaft.
