RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
Rear Bumper: Service and Repair
REAR BUMPER
REMOVAL
1. Raise and support the vehicle.
2. Remove the license plate.
3. Remove the bolts behind the plate.
4. Disconnect the license plate light electrical connectors.
5. Disconnect the trailer light connector electrical connection (if equipped).
6. Remove the two bolts along the front upper edge of the bumper near the frame tips.
7. Support the bumper with a suitable lifting device.
8. Remove the bolts attaching the bumper support brackets (4) to the trailer hitch (1).
INSTALLATION
