RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
Examine the lining contact pattern to determine if the shoes are bent or the drum is tapered. The lining should exhibit contact across its entire width.
Shoes exhibiting contact only on one side should be replaced and the drum checked for runout or taper.
Inspect the adjuster screw assembly. Replace the assembly if the star wheel or threads are damaged, or the components are severely rusted or
corroded.
Discard the brake springs and retainer components if worn, distorted or collapsed. Also replace the springs if a brake drag condition had occurred.
Overheating will distort and weaken the springs.
Inspect the brake shoe contact pads on the support plate, replace the support plate if any of the pads are worn or rusted through. Also replace the plate
if it is bent or distorted.
INSTALLATION
NOTE: On a new vehicle or after parking brake lining replacement, it is recommended that the parking brake system be conditioned prior to use.
This is done, by making one stop from 25 mph on dry pavement or concrete using light to moderate force on the parking brake foot pedal.
1. Reassemble the rear park brake shoes.
2. Install the axle shaft.
3. Install the park brake cable to the lever behind the support plate.
4. Unlock the park brake cable.
5. Install the disc brake rotor.
6. Install the disc brake caliper.
7. Adjust the rear brake shoes.
8. Install the tire and wheel assembly.
9. Lower the vehicle.
