RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
Front Crankshaft Seal: Service and Repair
CRANKSHAFT OIL SEAL FRONT
REMOVAL
1. Disconnect negative cable from battery.
2. Remove accessory drive belt.
3. Drain cooling system.
4. Remove upper radiator hose.
5. Remove radiator shroud attaching fasteners.
6. Remove radiator cooling fan and shroud.
7. Remove crankshaft damper bolt.
8. Remove damper using Special Tools 8513A Insert and 8454 Three Jaw Puller.
9. Using Special Tool 9071, remove crankshaft front seal.
INSTALLATION
CAUTION: The front crankshaft seal must be installed dry. Do not apply lubricant to sealing lip or to outer edge.
1. Using Special Tool 8348 and 8512A, install crankshaft front seal.
CAUTION: To prevent severe damage to the Crankshaft or Damper, thoroughly clean the damper bore and the crankshaft nose before installing
Damper.
2. Install vibration damper.
3. Install radiator cooling fan and shroud.
4. Install upper radiator hose.
5. Install accessory drive belt.
6. Refill cooling system.
7. Connect negative cable to battery.
