RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
Clutch Coil Lead Wire Harness - Typical
12. Remove the screw and retainer from the dutch coil lead wire harness on the compressor front housing.
Clutch Field Coil Snap Ring Remove - Typical
13. Remove the snap ring from the compressor hub and remove the dutch field coil. Slide the dutch field coil off of the compressor hub.
INSTALLATION
1. Install the clutch field coil and snap ring.
2. Install the screw and retainer on the clutch coil lead wire harness on the compressor front housing. Tighten screw to 2.2 Nm (20 in. lbs.).
3. Align the rotor assembly squarely on the front compressor housing hub.
4. Install the rotor bearing assembly with the installer (Special Tool C-6871 or equivalent). Thread the installer on the shaft, then turn the nut until
the rotor assembly is seated.
