RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
Driver/Vehicle Information Display: Service and Repair
Electronic Vehicle Information Center Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove overhead console. Refer to Overhead Console Removal and Installation in this section(Refer to OVERHEAD CONSOLE - REMOVAL).
3. Remove the screws holding the EVIC module in the overhead console.
4. Remove EVIC module from console assembly.
INSTALLATION
1. Position the EVIC module in the overhead console.
2. Install the screws holding the EVIC module in the overhead console.
3. Install the overhead console (Refer to OVERHEAD CONSOLE - INSTALLATION).
4. Connect the battery negative cable.
NOTE: If a new EVIC module has been installed, the compass will have to be calibrated and the variance set. Refer to Compass Variation
Adjustment and Compass Calibration in the Service Procedures section of this group for the procedures.