RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
f.
ASD relay.
g.
radiator fan relay.
h.
clutch interlock switch.
i.
brake switch.
j.
Autostick switch.
k.
fuel pump relay.
l.
starter relay. starter relay.
m.
transaxle solenoid connector.
n.
input and output speed sensor.
o.
PRNDL switch connector.
p.
For PT and JR vehicles: Install the front fascia.
q.
headlamps.
r.
turn signal lamps.
7.
Route the remainder of the harness to the PCM location.
8.
Carefully reconnect the PCM connector(s). This may take several attempts. Be sure to insert the connector straight into the module. If the
connector is not inserted straight into the module, it may cause the seal to move out of place.
9.
Verify that all seals are in place (Figure 2).
10.
Install the air cleaner assembly.
11.
Connect the positive battery cable and then the negative battery cable.
12.
Continue with Section F - PCM/Vehicle Data Set-up.
F. PCM/Vehicle Data Set-Up
1.
Connect the DRB III(R) to the data link connector located under the instrument panel. Turn the ignition key to the "ON" position.
2.
With the ignition switch in the "ON" position, determine if the vehicle is equipped with a SKIM module by using the DRB III and selecting from
the menu screen:
a.
Select # 1 - "DRB III Standalone" from Main Menu screen.
b.
Select # 1 - "1998 - 2004 Diagnostics" from Standalone Main Menu
screen.
c.
Select # 1 - "All (Except Below)" from 1998 - 2004 Diagnostics screen.
d.
Select # 8 - "System Monitor" from Select System screen.
e.
Select # 3 - "J1850 Module Scan" from Select Monitor screen and then press ENTER to continue and note if the vehicle is equipped with
SKIM.
>
If the vehicle is equipped with SKIM obtain the vehicle PIN (Personal Identification Number) before continuing with Step 3. This
information is available from the original selling invoice, the Dial VIP System, or by contacting the DaimlerChrysler Customer
Assistance Center (DCCAC). WARNING: Failure to use the SKIM PIN number to transfer the secret key code data from the SKIM
module will cause a no-start condition. If the vehicle is not equipped with SKIM then continue with Step 3.
f.
Press PAGE BACK.
