RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
g.
"NO"
h.
Enter the current odometer mileage and then press "Enter".
i.
Cycle the ignition key to the OFF position and back to the ON position and then press "Enter".
22.
Proceed as follows:
a.
If the vehicle is equipped with an automatic transmission, proceed to step 24.
b.
If the vehicle is equipped with a non-turbo engine and manual transmission, it is not necessary to set the pinion factor. Proceed to step 24.
c.
If the vehicle is equipped with a Turbo engine and manual transmission, proceed to step 23.
23.
On vehicles equipped with a Turbo engine and manual transmission, set the Pinion Factor. Using the DRBIII(R) select:
a.
"DRBIII® Standalone"
b.
"1998 - 2004 Diagnostics"
c.
"All (Except Below)"
d.
"Engine"
e.
"Miscellaneous"
f.
"Pinion Factor"
g.
Select the correct tire size and then select "Page Back" to exit.
h.
Proceed to step 24.
24.
On vehicles equipped with an automatic transmission, set the Pinion Factor. Using the DRBIII(R) select:
a.
"DRBIII(R) Standalone"
b.
"1998 - 2004 Diagnostics"
c.
"All (Except Below)"
d.
"Transmission"
e.
"Transmission Module"
f.
"Miscellaneous"
g.
"Pinion Factor"
h.
Select the correct tire size and then select "Page Back" to exit.
i.
Enter "Quick Learn" and then follow the instructions on the DRBIII(R).
NOTE:
Due to the PCM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKIM, etc.) within the vehicle, if so equipped.
Some DTC's may cause the MIL to illuminate. Check all modules using "Module Scan", record the DTC's, and erase these DTC's prior to returning
the vehicle to the customer. Erase any DTC's in the PCM only after all other modules have had their DTC's erased.
NOTE:
The following step is required by law.
