RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
-
A/C Heater Control Module
-
Powertrain Control Module (gas only)
-
Engine Control Module (diesel only)
-
Radio
-
Amplifier (if equipped)
-
Hands Free Module
-
Transfer Case Control Module (if equipped)
-
Sentry Key Immobilizer Module
-
Compass Mini-Trip Computer (if equipped)
-
Electro/Mechanical Instrument Cluster
Each module provides its own bias and termination in order to transmit and receive messages. The bus voltage is at zero volts when no modules are
transmitting and is pulled up to about seven and a half volts when modules are transmitting.
The bus messages are transmitted at a rate averaging 10800 bits per second. Since there is only voltage present when the modules transmit and the
message length is only about 500 milliseconds, it is ineffective to try and measure the bus activity with a conventional voltmeter. The preferred method
is to use the DRBIII(R) lab scope. The 12v square wave selection on the 20-volt scale provides a good view of the bus activity. Voltage on the bus
should pulse between zero and about seven and a half volts. Refer to the following figure for some typical displays.
The PCI Bus failure modes are broken down into two categories. Complete PCI Bus Communication Failure and individual module no response. Causes
of a complete PCI Bus Communication Failure include a short to ground or battery on the PCI circuit. Individual module no response can be caused by
an open PCI circuit at the module, or an open battery or ground circuit to the affected module.
Symptoms of a complete PCI Bus Communication Failure would include but are not limited to:
-
All gauges on the EMIC stay at zero
-
All telltales on EMIC illuminate
-
EMIC backlighting at full intensity
-
Dashed lines in the overhead console ambient temperature display
-
No response received from any module on the PCI bus (except the ECM/PCM)
-
No start (if equipped with Sentry Key Immobilizer)
Symptoms of Individual module failure could include any one or more of the above. The difference would be that at least one or more modules would
respond to the DRBIII(R).
Diagnosis starts with symptom identification. If a complete PCI Bus Communication Failure is suspected, begin by identifying which modules the
vehicle is equipped with and then attempt to get a response from the modules with the DRBIII(R). If any modules are responding, the failure is not
related to the total bus, but can be caused by one or more modules PCI circuit or power supply and ground circuits. The DRBIII(R) may display "BUS ±
SIGNAL OPEN" or "NO RESPONSE" to indicate a communication problem. These same messages will be displayed if the vehicle is not equipped with
that particular module. The CCD error message is a default message used by the DRBIII(R) and in noway indicates whether or not the PCI bus is
operational. The message is only an indication that a module is either not responding or the vehicle is not equipped.
