RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
a.
"DRBIII(R) Standalone"
b.
"1998 - 2004 Diagnostics"
c.
"All"
d.
"Engine"
e.
"Miscellaneous"
f.
"Check VIN"
g.
If the vehicle is not equipped with SKIM proceed to STEP # h. If the vehicle is equipped with SKIM follow the directions on the
DRBIII(R). When the VIN and SKIM key has been programmed, proceed to (STEP # 24).
h.
Enter the VIN as requested by the DRBIII(R).
24.
Update the PCM mileage. Using the DRBIII(R) select:
a.
"DRBIII(R) Standalone"
b.
"1998 - 2004 Diagnostics"
c.
"All (Except Below)"
d.
"Engine"
e.
"Miscellaneous"
f.
"Check PCM Odometer"
g.
"NO"
h.
Enter the current odometer mileage and then press "Enter".
i.
Cycle the ignition key to the OFF position and back to the ON position and then press "Enter".
25.
Reset pinion factor if necessary. Refer to the service information available in TechCONNECT or the appropriate service manual, section 8E,
Electronic Control Modules.
NOTE:
Due to the PCM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKIM, etc.) within the vehicle, if so equipped.
Some DTC's may cause the MIL to illuminate. Check all modules using "Module Scan", record the DTC's, and erase these DTC's prior to returning
the vehicle to the customer. Erase any DTC's in the PCM only after all other modules have had their DTC's erased.
NOTE:
The following step is required by law.
