RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
3.
Connect the 0H9404 StarSCAN vehicle cable to the StarSCAN and the vehicle (optional).
4.
Power ON the StarSCAN.
5.
Download the flash file from the Internet to the StarSCAN. Using the StarSCAN at the "Home" screen:
a.
Select "Flash Download"
b.
Select "Use connected vehicle" (StarSCAN must be connected to the vehicle) or "Enter information manually" (connection to the vehicle is
not necessary). Press the "Next" button and follow the on screen instructions.
c.
Select the appropriate calibration.
d.
Select "Download to Scantool".
e.
Select "Close" after the download is complete.
6.
Connect the CH9404 StarSCAN vehicle cable to the StarSCAN and the vehicle (if not already connected).
7.
Open the hood, install a battery charger and verify the battery state is above 12.5 volts.
8.
Download the tile from StarSCAN to the vehicle. Using StarSCAN at the "Home" screen:
a.
Select "ECU View"
b.
Browse the list of controllers using the scroll arrows. Highlight the PCM.
c.
Select "More Options"
d.
Select "ECU Flash"
e.
Highlight the appropriate PCM "Calibration" from the list.
f.
Select "Update Controller"
g.
When update is completed, select "OK"
NOTE:
Due to the PCM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKIM, etc.) within the vehicle, if so equipped.
Some DTC's may cause the MIL to illuminate. Check all modules using "ECU View" from the Home screen, record the DTC's, and erase these
DTC's prior to returning the vehicle to the customer. Erase any DTC's in the PCM only after all other modules have had their DTC's erased.
NOTE:
The following step is required by law.
9. Type the necessary information on the "Authorized Modification Label" p/n 04275086AB and attach near the VECI label (Fig. 4).
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
