RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
12.
Select the "Vehicle Option" tab.
13.
Under the "Vehicle Option window, identify and record:
a.
Engine.
b.
Emissions (Federal or California).
c.
Transmission (Automatic, 5-speed manual, etc.).
14.
Connect the DRBIII(R) to TechCONNECT and the vehicle. Open TechTOOLS and verify that the "DRBIII(R) Status: Connected" message is in
the upper right corner of the TechTOOLS screen.
15.
TechTOOLS should automatically populate the VIN in the "Vehicle Criteria area and the available updates. If not, manually enter the VIN then
TechTOOLS will populate the available updates.
NOTE:
Do NOT enter the generic controller part number in step 16a below.
16.
Determine the proper calibration:
a.
If the old "PCM part # " is known, enter the part number of the old controller in the "Parts Criteria p/n window. Proceed to step 16.
b.
If the old "PCM part # " is not known, select the correct calibration based on the information that was recorded from "Vehicle Options" in
step 13.
17.
Select the correct calibration.
18.
Select the "Download/Update button.
19.
Monitor the "Flash Download/Update Progress" window on the TechCONNECT and follow the instructions on TechCONNECT/DRBIII(R).
When the flash process is completed, proceed to next step.
20.
Enter the VIN in the PCM. Using the DRBIII® select:
a.
"DRBIII Standalone"
b.
"1998 - 2004 Diagnostics"
c.
"All"
d.
"Engine"
e.
"Miscellaneous"
f.
"Check VIN"
g.
If the vehicle is not equipped with SKIM proceed to step 20h. If the vehicle is equipped with SKIM follow the directions on the DRBIII(R).
When the VIN and SKIM key has been programmed, proceed to step 20.
h.
Enter the VIN as requested by the DRBIII(R).
21.
Update the PCM mileage. Using the DRBIII(R) select:
a.
"DRBIII(R) Standalone"
b.
"1998 - 2004 Diagnostics"
c.
"All (Except Below)"
d.
"Engine"
e.
"Miscellaneous"
f.
"Check PCM Odometer"
