RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
10.
Place the new wiring harness into position.
11.
Connect the wiring harness to the following items located in the engine compartment as necessary:
a.
purge solenoid.
b.
idle speed motor.
c.
throttle position sensor.
d.
intake air temperature sensor.
e.
air conditioning transducer switch.
f.
injector harness.
g.
camshaft position sensor.
h.
speed control servo.
i.
upstream and downstream oxygen sensors.
j.
leak detection pump.
k.
oil pressure sensor.
l.
starter battery positive wire (B+)
m.
transaxle solenoid connector.
n.
input and output speed sensor.
o.
PRNDL switch connector.
p.
crankshaft position sensor.
q.
starter solenoid.
r.
generator field wire connector.
s.
generator battery positive wire.
t.
air conditioning clutch coil.
12.
Connect the ground eyelets.
13.
Connect the harness connectors that connect to the PDC.
14.
Rotate the PDC into position and install the cover.
15.
Route the remainder of the harness to the PCM location.
16.
Carefully reconnect the PCM connector(s). This may take several attempts. Be sure to insert the connector straight into the module. If the
connector is not inserted straight into the module, it may cause the seal to move out of place.
17.
Verify that all seals are in place (Figure 2).
18.
For RS/CS vehicles, install the left side fender shield.
19.
Install the air cleaner assembly.
20.
Install the battery tray and battery.
21.
Connect the positive battery cable and then the negative battery cable.
