RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
1. Clean out machined hole in cylinder head.
2. Apply a small amount of engine oil to sensor O-ring.
3. Install sensor into cylinder head with a slight rocking action. Do not twist sensor into position as damage to O-ring may result.
CAUTION: Before tightening sensor mounting bolt, be sure sensor is completely flush to timing chain cover. If sensor is not flush, damage to
sensor mounting tang may result.
4. Install mounting bolt and tighten. Refer to Torque Specifications.
5. Connect electrical connector to sensor.
