RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
Steering Wheel: Service and Repair
REMOVAL
1. Disable and remove the driver's side airbag.
2. Partially remove the steering wheel bolt and leave the bolt in the column.
Fig. 21
3. Install puller CJ98-1 or equivalent using the top of the bolt to push on.
4. Remove and discard the steering wheel bolt.
5. Remove the steering wheel.
INSTALLATION
NOTE: Do not reuse the old steering wheel bolt (a new bolt must be used)
1. Install steering wheel to the column
NOTE: Be certain that the steering wheel mounting bolt is tightened to the proper torque specification to ensure proper clockspring operation.
2. Install the new steering wheel bolt. Tighten the bolt to 61 Nm (45 ft. lbs.).
3. Install the driver's side air bag.
