RAM 2500 Truck 2WD V8-5.7L VIN D (2004)
Fig. 19
1. Install the hub/bearing to the steering knuckle and tighten the bolts to 163 Nm (120 ft. lbs.) (LD) or 176 Nm (130 ft. lbs.) (HD 4X2).
2. Install the knuckle onto the upper and lower ball joints.
3. Install the upper and lower ball joint nuts. Tighten the upper ball joint nut to 54 Nm (40 ft. lbs.) (on 1500 series only an additional 90° turn is
required) and the lower ball joint nut to 52 Nm (38 ft. lbs.) (on 1500 series only an additional 90° turn is required) (LD) or 135 Nm (100 ft. lbs.)
(HD 4X2).
4. Remove the hydraulic jack from the lower suspension arm.
5. Install the tie rod end and tighten the nut to 61 Nm (45 ft. lbs.).
6. Install the front halfshaft into the hub/bearing (if equipped).
7. Install the halfshaft nut and tighten to 251 Nm (185 ft. lbs.) (if equipped).
8. Install the ABS wheel speed sensor if equipped and brake shield, rotor and caliper.
9. Install the wheel and tire assembly.
10. Remove the support and lower the vehicle.
11. Perform a wheel alignment.
