RAM 2500 Truck 2WD V8-5.9L VIN 5 HDC (1998)
5.
Remove the three screws that secure the flame shield to the lower instrument panel (Figure 1).
6.
Pull the flame shield away from the lower instrument panel far enough to disengage the two retaining tabs on the top, then lower the shield far
enough to access the ash receiver lamp housing and bulb.
7.
Disengage the ash receiver lamp and housing retaining clip from the mounting hole in the flame shield then, disconnect the ash receiver lamp.
8.
Install the new ash receiver bulb, p/n L0000161, and ash receiver lamp housing, p/n 05269360, onto the mounting hole of the flame shield.
9.
Install the flame shield onto the lower instrument panel and secure it with the three screws. Torque the screws to 2.2 Nm (20 in. lbs).
10.
Remove the tape from the instrument panel bezel.
11.
Install the ash receiver.
12.
Connect the battery negative cable(s).
13.
Program the radio station presets recorded in step 1 and set the clock.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
08-50-13-90
0.2 Hrs.
FAILURE CODE: P8 - New Part
