RAM 2500 Truck 2WD V8-5.9L VIN 5 HDC (1998)
Clutch/Brake Pedal Mounting
4. Remove retainer from passenger side of pedal pivot shaft.
5. Push pedal pivot shaft toward driver side of support only enough to remove clutch pedal. It is not necessary to remove shaft from pedal support
entirely.
6. Remove clutch pedal.
INSTALLATION
Clutch/Brake Pedal Bushings
1. Inspect bushings in clutch and brake pedals. Replace bushings if worn, cracked, or distorted.
2. Lubricate pedal shaft, pedal shaft bore and all bushings with MOPAR Multi Mileage, or high temperature bearing grease.
3. Position clutch pedal in support. Align pedal with pivot shaft and slide shaft through pedal bushings. Then repeat process for brake pedal.
4. Slide pedal shaft through support and install shaft retainer.
5. Secure push rods to clutch and brake pedals.
6. Install brake light switch in bracket. Rotate switch into place to lock it in bracket.
7. Install knee bolster.