RAM 2500 Truck 2WD V8-5.9L VIN 5 HDC (1998)
Pinion Rear Bearing Cup Installation
1. Apply Mopar8 Door Ease stick lubricant to outside surface of bearing cup. Install the pinion rear bearing cup with Installer D-111 and Handle
C-4171. Ensure cup is correctly seated.
Pinion Front Bearing Cup Installation
2. Apply MOPAR Door Ease stick lubricant to outside surface of bearing cup. Install the pinion front bearing cup with Installer D-146 and Handle
C-4171.
3. Install pinion front bearing and oil slinger, if equipped. Apply a light coating of gear lubricant on the lip of pinion seal.
Pinion Seal Installation
4. Install seal with Installer 8108 and Handle C-4171.
NOTE: Pinion depth shims are placed between the rear pinion bearing cone and pinion gear to achieve proper ring and pinion gear mesh. If the
factory installed ring and pinion gears are reused, the pinion depth shim should not require replacement or adjustment. Refer to Pinion Gear Depth
paragraph in this section to select the proper thickness shim before installing rear pinion bearing cone.
