RAM 2500 Truck 2WD V8-5.9L VIN Z (1997)
5. Install O-ring into the back of the stub shaft.
6. Install stub shaft and valve assembly in the housing. Line up worm shaft to slots in the valve assembly.
7. Install thrust support assembly.
NOTE: The thrust support is serviced as an assembly. If any component of the thrust support is damaged the assembly must be replaced.
8. Install adjuster nut and lock nut.
9. Adjust Thrust Bearing Preload and Over-Center Rotating Torque.
Rack Piston and Worm Shaft
The content of this article reflects changes called for in TSB 26-01-97.
DISASSEMBLY
1. Remove housing end plug.
2. Remove rack piston plug.
3. Remove side cover and pitman shaft.
4. Turn stub shaft COUNTERCLOCKWISE until the rack piston begins to come out of the housing.