RAM 2500 Truck 2WD V8-5.9L VIN Z (1997)
Seals and Gaskets: Service and Repair
REMOVAL
1. Raise vehicle.
2. Mark propeller shaft and axle yoke for alignment reference.
3. Disconnect and remove propeller shaft.
4. Remove old seal with Seal Remover C-3985-B, or equivalent from overdrive housing.
INSTALLATION
1. Place seal in position on overdrive housing.
2. Drive seal into overdrive housing with Seal Installer C-3995-A, or equivalent.
3. Carefully guide propeller shaft slip yoke into housing and onto output shaft splines. Align marks made at removal and connect propeller shaft to
rear axle pinion yoke.