RAM 2500 Truck 2WD V8-5.9L VIN Z LDC (2000)
Hood Striker: Service and Repair
LATCH STRIKER/SECONDARY CATCH
REMOVAL
Fig. 4
1. Disconnect and remove the secondary release handle. (Fig. 4)
2. Remove the two bolts and remove the striker/catch assembly.
INSTALLATION
1. Install the latch striker/secondary catch and install the bolts.
2. Tighten the bolts to 11 N.m (8 ft.lbs).
3. Install the release handle and connect to the secondary catch.
4. Check the hood fit and adjust if required. Refer to Body and Frame / Specifications / Dimensions.
