RAM 2500 Truck 2WD V8-5.9L VIN Z LDC (2000)
13. Apply Mopar Silicone Rubber Adhesive Sealant, or equivalent, at bearing cap to block joint to provide cap to block and oil pan sealing (Fig. 71).
Apply enough sealant until a small amount is squeezed out. Withdraw nozzle and wipe excess sealant off the oil pan seal groove.
14. Immediately install the oil pan.
LOWER SEAL REPLACEMENT
1. Remove the oil pan.
2. Remove the oil pump from the rear main bearing cap.
3. Remove the rear main bearing cap and discard the old lower seal.
4. Clean the rear main cap mating surfaces including the oil pan seal grooves.
5. Carefully install a new upper seal (refer to the Upper Seal Replacement - Crankshaft Installed procedure above).
6. Lightly oil the new lower seal lips with engine oil.
7. Install a new lower seal in bearing cap with white paint facing the rear of engine.
Fig. 70
8. Apply 5 mm (0.20 in) drop of Loctite 518, or equivalent, on each side of the rear main bearing cap (Fig. 70). DO NOT over apply sealant or allow
the sealant to contact the rubber seal. Assemble bearing cap to cylinder block immediately after sealant application.
9. To align the bearing cap' use cap slot, alignment dowel and cap bolts. DO NOT remove excess material after assembly. DO NOT strike rear cap
more than 2 times for proper engagement.
10. Install the rear main bearing cap with cleaned and oiled cap bolts. Alternately tighten the cap bolts to 115 Nm (85 ft. lbs.) torque.
11. Install oil pump.
Fig. 71
12. Apply Mopar Silicone Rubber Adhesive Sealant, or equivalent, at bearing cap to block joint to provide cap to block and oil pan sealing (Fig. 71).
Apply enough sealant until a small amount is squeezed out. Withdraw nozzle and wipe excess sealant off the oil pan seal groove.
13. Immediately install the oil pan.
