RAM 2500 Truck 4WD L6-359 5.9L DSL Turbo VIN D FI (1998)
Catalytic Converter: Service and Repair
REMOVAL
1. Raise and support vehicle.
2. Saturate the bolts and nuts with heat valve lubricant. Allow 5 minutes for penetration.
Catalytic Converter
3. Remove clamps and nuts.
4. Remove the catalytic converter.
INSTALLATION
1. Assemble converter and clamps loosely to permit proper clearance with exhaust heat shields and underbody parts.
2. Tighten all clamp nuts to 43 Nm (32 ft. lbs.) torque.
3. Lower the vehicle.
4. Start the engine and inspect for exhaust leaks and exhaust system contact with the body panels. Adjust the alignment, if needed.
