RAM 2500 Truck 4WD L6-359 5.9L DSL Turbo VIN D FI (1998)
21. Tighten the pump shaft nut to 15 N.m (11 lb. ft.) torque to seat the gear to the pump shaft taper.
22. Remove injection pump shaft nut. Use a magnet on the end of the shaft while removing.
23. Remove special bearing and thrust washers #6862 from pump shaft. Use a magnet on the end of the shaft while removing.
24. While preventing the engine from rotating with the barring tool, tighten the shaft nut to 165 N.m (122 lb. ft.) torque.
25. Repeat steps 12 and 13 to verify that the final timing setting is correct. If the setting is not correct, repeat steps 15 through 25.
26. Remove the dial indicator and adaptor from the injection pump.
CAUTION: The following installation and torquing procedure must be followed exactly. Improper installation of the delivery valve will result in
damage or leaks.
27. Install the delivery valve assembly on top of the sealing washer.
28. Lubricate the threads and clamping surface of the delivery valve holder with a few drops of SAE 90 hypoid gear oil. Do not lubricate the metal
delivery valve washer or its seating area.
29. Install the delivery valve holder assembly taking care not to displace the delivery valve spring, fill piece, or any shims.
