RAM 2500 Truck 4WD L6-359 5.9L DSL Turbo VIN D FI (1998)
Checking Front Output Seal Installation Depth
c. Remove installer and verify that seal is recessed the proper amount. Seal should be 2.03 to 2.5 mm (0.080 to 0.100 inch) below top edge of
seal bore in front case. This is correct final seal position.
CAUTION: Be sure the front output seal is seated below the top edge of the case bore as shown. The seal could loosen, or become cocked if
not seated to recommended depth.
Installing Flange Seal On Front Shaft
2. Install companion flange seal on front shaft.
Instaling Companion Flange On Front Shaft
3. Install companion flange on front shaft. Then install and tighten flange nut to 176 - 271 Nm (130 - 200 ft. lbs.) torque.
