RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 6 (1999)
Rocker Arm Assembly Identification
CAUTION: When removing the rocker arms, the sockets may come loose and fall into the engine. Make sure they stay with the arm upon
removal/Installation.
Push Rod Removal/Installation
4. Lift the push rod(s) up and out of the engine. Mark them so they can be installed in their original position.
NOTE: The #5 cyl. exhaust and #6 cyl. intake and exhaust push rods must be raised through the provided cowl panel access holes.
5. Lift the crosshead(s) off of the valve stems. Mark them so they can be installed in their original position.
CLEANING
Clean all components in a suitable solvent. If necessary, use a wire brush or wheel to remove stubborn deposits. Rinse in hot water and blow dry with
compressed air, Inspect oil passages in rocker arms and pedestals. Apply compressed air to lubrication orifices to purge contaminants.
INSPECTION
Rocker Arms