RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 6 (1999)
Removing Seal From Cover
16. Support the cover on a flat work surface with wooden blocks, and using a suitable punch and hammer, drive the old seal out of the cover from the
outside of the cover.
INSTALLATION
1. Apply a bead of Mopar(R) Stud & Bearing Mount to the outside diameter of the seal. Do not lubricate the inside diameter of the new seal.
Installing Seal Into Cover With Tool 8281
2. With the cover supported by wood blocks, install the seal into the rear of the cover using crankshaft seal installer Special Tool 8281 and driver
handle C-4171. Strike the driver handle until the installation tool bottoms out on the inside of the cover.
3. Install the plastic seal pilot (provided with seal kit) into the crankshaft seal.
4. Apply a bead of Mopar(R) Silicone Rubber Adhesive Sealant or equivalent to the gear housing cover sealing surface.
