RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 6 (1999)
Installing Front Cover With Seal Pilot
5. Install the cover to the gear housing, aligning the seal pilot with the nose of the crankshaft.
6. Install the cover bolts and tighten to 24 Nm (18 ft. lbs.) torque. Remove pilot tool.
7. Install the crankshaft damper and torque the bolts to 125 Nm (92 ft. lbs.). Use the engine barring tool to keep the engine from rotating during
tightening operation.
8. Install the fan support/hub assembly and torque bolts to 4 Nm (18 ft. lbs.).
9. Install the accessory drive belt.
10. Connect battery negative cables.
11. Start engine and check for oil leaks.
