RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 6 (1999)
Power Distribution Center: Service and Repair
Fig 3 Engine Wire Harness In-line Connector
NOTE: The Power Distribution Center (PDC) is serviced as a unit with the headlamp and dash wire harness. If any internal circuit of the PDC or if the
PDC housing is faulty or damaged, the entire PDC and the headlamp and dash wire harness unit must be replaced.
POWER DISTRIBUTION CENTER REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Disconnect each of the headlamp and dash wire harness connectors.
3. Remove all of the fasteners that secure each of the headlamp and dash wire harness ground eyelets to the vehicle body and chassis components.
4. Disengage each of the retainers that secure the headlamp and dash wire harness to the vehicle body and chassis components.
5. Unlatch and remove the cover from the PDC.
6. Remove the screw that secures the engine wire harness in-line connector to the PDC and disconnect the connector.
Fig 4 Battery Cable PDC Connections
7. Remove the nut that secures the eyelet of the battery negative cable take out to the rearward stud in the PDC and remove the eyelet from the stud.
8. Remove the nut that secures the eyelet of the battery positive cable take out to the forward stud in the PDC and remove the eyelet from the stud.
