RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 6 (1999)
Oil Pressure Sensor: Service and Repair
REMOVAL
1. Disconnect the battery negative cables.
Oil Pressure Sensor Location
2. Disconnect the oil pressure sensor connector.
3. Using a suitable socket, remove the oil pressure sensor from the block (counter-clockwise).
INSTALLATION
Oil Pressure Sensor And O-Ring
1. If the sensor is not being replaced, inspect the O-ring and replace if necessary.
2. Install the oil pressure sensor and tighten to 16 Nm (144 inch lbs.) torque.
3. Connect the battery negative cables.
4. Start engine and check for oil leaks at the sensor.
