RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 6 (1999)
Fig. 96
7. Install retainer plate on governor body and around solenoid (Fig. 96). Be sure solenoid connector is positioned in retainer cutout.
8. Align screw holes in governor body and transfer plate. Then install and tighten governor body screws to 4 Nm (35 inch lbs.) torque.
Fig. 97
9. Connect harness wires to governor pressure solenoid and governor pressure sensor (Fig. 97).
10. Perform Line Pressure and Throttle Pressure adjustments, refer to Adjustments, Control Pressure Adjustments for proper procedures.
11. Install fluid filter and pan.
12. Lower vehicle.
13. Fill transmission with recommended fluid and road test vehicle to verify repair.
