RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
7. Remove the two back regulator bolts and loosen the front two.
8. Slide the regulator up and out of the keyhole slots in the door panel.
9. Remove the regulator through the hole in the inner door panel.
INSTALLATION
1. Install the regulator through the hole in the inner door panel.
2. Position the regulator bolts into the keyhole slots and slide into place.
3. Install the back regulator bolts and tighten all four to 10 N.m (89 in.lbs).
4. Position the stabilizer, install the nuts and tighten to 10 N.m (89 in.lbs).
5. Using the window handle raise the regulator to the position shown in (Fig. 11).
6. Remove the glass support and connect to the regulator lift plate.
7. Install the glass nuts and tighten to 10 N.m (89 in.lbs).
8. Disconnect the window switch and install into the door trim panel.
9. Using the window handle raise the regulator to the position shown in.
