RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
5.
Disengage the parking brake cable from behind the rotor assembly (Fig. 4).
6.
Compress cable tabs on each cable end fitting at the brake cable support plate.
7.
Remove the cables from the brake cable support plates.
8.
Perform Steps 3 - 7 to the other rear parking brake cable.
9.
Push the new parking brake cable (see Parts Required section) end through the brake cable support plate hole until the cable end fitting tabs lock
into place.
NOTE:
PULL ON THE CABLE TO ENSURE IT IS LOCKED INTO PLACE.
10.
Push the cable through the frame bracket.
11.
Perform Steps 9 and 10 to the other rear parking brake cable.
12.
Lock the left cable end fitting tabs into the frame bracket hole.
13.
Install the rear cable(s) into the tensioner rod behind the rear of the brake assembly.
14.
Install the cable to the intermediate cable connector.
15.
Release and remove the lock out device.
16.
Lower the vehicle enough for access to the parking brake foot pedal. Then depress the parking brake pedal to the floor.
NOTE:
LEAVE PARKING BRAKES APPLIED UNTIL ADJUSTMENT IS COMPLETE.
17.
Raise the vehicle again.