RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
Fuel Supply Line: Service and Repair
High Pressure Fuel Lines Replacement
REMOVAL
High-pressure lines are used between the fuel injection pump and the fuel injectors only. All high-pressure fuel lines are of the same length and inside
diameter. Correct high-pressure fuel line usage and installation is critical to smooth engine operation.
CAUTION: Refer to Cleaning Fuel System Parts.
1. Disconnect both negative battery cables from both batteries. Cover and isolate ends of cables.
Fig. 39 Cable/Lever/Throttle Linkage Cover
2. Thoroughly clean fuel lines at cylinder head and injection pump ends.
3. Remove cable cover (Fig. 39). Cable cover is attached with 2 Phillips screws, 2 plastic retention clips and 2 push tabs (Fig. 39). Remove 2 Phillips
screws and carefully pry out 2 retention clips. After clip removal, push rearward on front tab, and upward on lower tab for cover removal. Do not
remove any cables at lever.
