RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
6. Install and tighten the five screws that secure the passenger airbag front and rear mounting brackets to the instrument panel. Tighten the screws to
9 Nm (80 in. lbs.).
7. Install and tighten the four screws that secure the two plastic support brackets of the passenger airbag door panel outlet housing to the glove box
opening upper reinforcement. Tighten the screws to 2.2 Nm (20 in. lbs.).
8. Reach through and above the glove box opening to access and reconnect the passenger airbag pigtail wire connector to the instrument panel wire
harness connector. Be certain that the passenger airbag pigtail wire connector is fully engaged with and latched to the instrument panel wire
harness connector.
9. Reinstall the glove box opening upper trim onto the instrument panel.
10. Reinstall the glove box onto the instrument panel.
11. Do not reconnect the battery negative cable at this time. The airbag system verification test procedure should be performed following service of
any airbag system component. (Refer to RESTRAINTS - STANDARD PROCEDURE - VERIFICATION TEST).
