RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
Band Apply Servo: Service and Repair
Rear Servo
DISASSEMBLY
1. Remove small snap-ring and remove plug and spring from servo piston (Fig. 219).
2. Remove and discard servo piston seal ring.
CLEANING
Remove and discard the servo piston seal ring (Fig. 220). Then clean the servo components with solvent and dry with compressed air. Replace either
spring if collapsed, distorted or broken. Replace the plug and piston if cracked, bent, or worn. Discard the servo snap-rings and use new ones at
assembly.
ASSEMBLY