RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
Transmission Cooler: Service and Repair
Air to Oil Cooler
REMOVAL-AIR TO OIL COOLER
1. Remove front bumper.
2. Place a drain pan under the oil cooler.
3. Raise the vehicle.
4. Disconnect the oil cooler quick connect fittings from the transmission lines.
5. Remove the charge air cooler-to-oil cooler bolt (Fig. 8).
6. Remove two mounting nuts.
7. Remove the oil cooler and line assembly towards the front of vehicle. Cooler must be rotated and tilted into position while removing.
INSTALLATION-AIR TO OIL COOLER
1. Carefully position the oil cooler assembly to the vehicle.
2. Install two nuts and one bolt. Tighten to 11 Nm (95 inch lbs.) torque.
3. Connect the quick connect fittings to the transmission cooler lines.
4. Install front bumper.
5. Start the engine and check all fittings for leaks.
6. Check the fluid level in the automatic transmission.
