RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
Valve Body: Service and Repair
Installation
INSTALLATION
1. Check condition of O-ring seals on valve body harness connector (Fig. 314). Replace seals on connector body if cut or worn.
2. Check condition of manual lever shaft seal in transmission case. Replace seal if lip is cut or worn. Install new seal with 15/16 deep well socket
(Fig. 315).
3. Check condition of seals on accumulator piston (Fig. 316). Install new piston seals, if necessary.
4. Place valve body manual lever in low (1 position) so ball on park lock rod will be easier to install in sprag.
5. Lubricate shaft of manual lever with petroleum jelly. This will ease inserting shaft through seal in case.
